Clothing the Raspberry Pi (Or Getting the Raspberry Pi a Case)

Before I even had a Raspberry Pi, I purchased this project box from eBay hoping that from the schematic measurements of the Raspberry Pi, it would fit. When I got my Raspberry Pi on April 19th, I was much more concerned with playing with it and my upcoming AP exams than casing it. This past weekend, I pulled out the project box and began to fit the Raspberry Pi inside it.

I used an X-Acto knife to cut out the pieces of plastic from the box. The USB ports, RCA jack, and headphone jack all stick out past the sides of the box – to make them fit, I had to trim down extra material from the top of the box to allow them to slip in. The rest of the ports are flush except for the power jack and sd card slot, both of which are less than 1 inch shy of the box’s edge. For those ports that didn’t need to be cut top-down, I used the Punnet template to get the sizes of the ports down correctly. I taped it onto the project box sides and then used a drill to take out most of the holes. I then used the X-Acto knife to straighten them out.

To provide a bed for the Pi to sit on, I cut out strips from the pink piece of foam that the Pi shipped on and hotglued a small piece in each corner the Pi would touch.

Overall, I am very pleased with how my case for the Raspberry Pi came out, even though it’s not perfect by any means. I just wish their store was available again so that I could buy a couple of Raspberry Pi logo stickers for the plain box.

So far, I’ve tested it with the box closed for 3 days running as an AirPrint server (see the demo) and have not had any overheating issues. To the touch, the lid of the box is a little warm but nothing significant. I’ve included a small photo gallery for anyone interested.

Project Box (Closed)

Image 1 of 11

10 thoughts on “Clothing the Raspberry Pi (Or Getting the Raspberry Pi a Case)

  1. Milli

    Good job dude!! Now I am going to do exactly what you have. Thank you for sharing this with us. Keep it coming.

    Reply
    1. Rohan Kapoor

      In theory I suppose… If you're suggesting putting the Raspberry Pi in upside down and cutting the ports out that way, I would say that would work. I wouldn't however just put the lid side down, more than likely the Raspberry Pi would fall out.

      Reply
  2. Overseer James

    Duude! Your images are so unoptimized! 5MB for a picture? Seriously?!? You should really learn to optimize your images or else they are going to eat your bandwidth. That aside, this is a really nice box. It's pretty cheap, so I guess I can buy one for my Raspberry Pi, in the lack of something more better looking.

    James of New Fallout

    Reply
  3. Yinz Lia

    Hiya, I’m really glad I have found this info. Nowadays bloggers publish only about gossip and web stuff and this is actually frustrating. A good site with interesting content, this is what I need. Thanks for making this site, and I will be visiting again. Do you do newsletters by email?
    dewa poker
    raja poker
    togel online

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *